How do you relearn a idle on a 2005 Nissan Altima?

2005 nissan altima 2.5 idle relearn procedure: Insert key into ignition. Turn key to “On” position. Turn key to “off” position. Turn key to “on” position. Depress accelerator pedal fully 5 times within 5 seconds. Wait exactly 7 seconds then Hold accelerator pedal. After blinking SES light goes solid, (20 seconds) release. Click to see full answer. Also asked, how do you relearn a Nissan idle? How to Do a Nissan Altima Idle Relearn Without stepping on the gas pedal, turn the ignition switch to on and wait at least two seconds, then turn the ignition switch off and wait 10 seconds. Turn the ignition switch on again and wait two seconds, then off again for 10 seconds. Start the engine and run it until it gets to operating temperature. Secondly, does a throttle body need to be programmed? In fact, on some engines a new throttle body needs to be programmed with a factory, or equivalent, scan tool. The technician cannot even clean the carbon out of the throttle body in some cases without setting a “check engine” light. Furthermore, how do I reset my electronic throttle body? Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.How do I adjust the idle speed on my electronic throttle body? MINIMUM IDLE SPEED ADJUSTMENT Set the parking brake and block the drive wheels. Start and run the engine until it reaches normal operating temperature. Stop the engine, then disconnect and plug any vacuum lines, as required. Using an awl, pierce the idle stop screw cap and carefully pry the cap from the throttle body.